











T-100.4AB // 640 Watts RMS 4-Channel Car Audio Amplifier
You Save 25% ($62.50)
$189.99CT Sound’s proudly introduces the T-100.4 Car 4 Channel Amplifier. This one lay in one of the best class car amplifiers. Providing with the best audio quality output, lowest possible distortion, staggering outlook and sleek design; the T-100.4 comes to you with top class steel body finishing! This is a nice class AB operative 4-channel car audio amplifier with bridgeable capability. As less as possible physical wirings are used inside the amplifier; ensuring lower resistivity and heat emission. Plus, the outer steel body and the fins on the side works as a true heat sink to drain the internal heats fast! This is real smart, handy & real easy car amp for users.
Quick Facts: | |
RMS Power: 2Ω @ 14.4v | 160 Watts x 4-Channels |
RMS Power: 4Ω @ 14.4v | 100 Watts x 4-Channels |
RMS Power: 4Ω @ 14.4v | 320 Watts x 2-Channels Bridged |
Power & Ground Input Size: | 4 Gauge |
Speaker Input Size: | 12 Gauge |
Technical Specifications:
- No of channel: 4
- Frequency response (-3dB): 10Hz ~ 50kHz
- Gain adjustment: 0.2v ~ 5v
- Channel separation: 50dB
- Signal to noise ratio: 100dB
- Damping factor: 150
- Minimum speaker impedance: 2Ω (ohms)
- Low pass filter: 30Hz ~ 300Hz
- High pass filter: 30Hz ~ 600Hz
- Operating voltage (-ve ground): DC 12v
Dimensions:
- 181mm (W) x 55mm (H) x 420mm (L)
Features:
- This amp has bridgeable outputs
- TRI mode capable (for 3 speakers)
- MOSFET PWM (Pulse Width Modulated) power supply
- Soft turn on circuitry
- Variable input gain control, high-pass & low-pass crossover
- Built in thermal, DC offset, overload and speaker short protection
- Nickel plated RCAs ensuring low resistance inputs & outputs
- LED power and protection indicators
- This is a purely Class-AB amplifier
Solid amp with enough power to drive my components and coaxials. Just wished it was fused. Has smooth threads for all the screws
I'm running this amp in a single cab sonoma as a 3 channel set up. A set of strato 6.5 components on the front 2 channels and bridged channels 3 and 4 to run a 10" shallow sub and I'm very happy with the sound.
I'm running this amp bridged pushing 2 Sony 12" subs. Took a little fine tuning and it does the job just fine. Clear sound absolutely 0 distortion even when reaching the 85-90% volume level. Speakers are mounted in a custom made Corian box that weighs upwards of 90lbs. Very solid and dense material with ability to flex producing lows you can feel without 1000's of watts. 4 stars because it will only run for about 30-40 minutes then the thermal switch trips. This amp should have an internal fan because it runs too hot when being pushed. But the sound quality is amazing.