You Save 21% ($90.04)$329.95
Strato 8 Inch D4 Subwoofers QTY: 2
CT-1000.1D Monoblock Amplifier QTY:1
(QTY: 3 PCS TOTAL)
Sub power: 450W (RMS) | 900W (MAX)
Subwoofer size: 8"
Subwoofer type/ impedance: Dual 4 ohm
Voice coil (diameter): 2" (50.8mm)
VAS: 8.08 liters
SPL: 82.60 dB (@1w/1m)
Xmax: 12.5mm (One way)
Displacement: 0.12 ft3
Magnet weight: 90 Oz
Speaker connector: 12 Gauge
Resonant frequency: 30.5Hz
Sealed: 0.30 ft3
Ported: 0.40 ~ 0.65 ft3
RMS Power: 1x1000w@1ohm
RMS Power: 1x650w@2ohm
RMS Power: 1x350w@4ohm
Subsonic filter: 0 - 50Hz
Frequency response: 0 Hz to 320 Hz
Bass Boost: 0 to 12 dB
Bass Boost Frequency: 30-80Hz
Input impedance: 22k ohms
Operation voltage: DC 9-16V
Minimum speaker impedance: 1ohm
Remote volume Controller
Continuously-Variable Input Gain Control
Remote Turn-on/Turn-off circuit
MOSFET Pulse Width Modulated Power Supply
Soft Turn-on Circuit
Thermal and Speaker Short Protection Circuit
LED Power and Protection Indicators
Why is it red and white wire unlike all your other ofc kits like the big 3 that has blue and white wire and why would it not come with your best rca cables that are ofc too. Seams like you cut corners but it still works just match the colors in all your kits of wires together and include your premium rca cables in a Elite series ofc wiring kit and it would really be a Elite kit.
Got an at125.4 to run 2 sets of Meso 6.5 component sets and they sound amazing the look of it and the sound of everything is the reason I will only run ct sounds in all my builds from now on
Got some notes from ct box and played around with some numbers to come up with what I was looking for .
Ct box is a great place to start with numbers to fit your needs of what your looking for out of a box.
I couldn't stop with just 2 so I ended up doing 4 8s .
Was a fun bulid and still learning of course .thanks for the help Mr Mark.
Ol and also has 2 different tops Orange place for show .
And the other top Just plane MDF
Have not hooked up yet I'm sure this thing is going to bang but damn when I got it it was just a little box inside a big box with nothing to stop it from slamming around there's a couple of Nicks couple scrapes I paid $1,350 not too happy about that but I'm sure the amps will do what it's supposed to assuming it works after getting banged around it completely tore out of the inner box because there was no padding inside
I have it in a 1cuft net volume slot port enclosure tuned to 35hz as specified by CTSounds. It hits pretty hard at the low volume I have it at for the moment (since it isn’t broken in yet). It’s powered by a ct1000.1 wired at 1ohm.