$10.00

Notification of the PRICING, our BIGGEST DISCOUNT, BEST DEAL, will be announced by email approximately two weeks before departure to the USA. You will have 72-hours to purchase (the balance owed). If you choose not to buy, CT Sounds will refund your $10 reservation fee within 7 business days. We anticipate orders will ship out 60-90 days after the container ship departs for the USA.

 

 

Power Ratings:

RMS Power: 80w @ 4-ohm x 4-channels at 14.4v 1% THD

RMS Power: 110w @ 2-ohm x 4-channels at 14.4v 1% THD

RMS Power: 160w @ 4-ohm Bridged x 2-channels at 14.4v 1% THD

 

Technical Specifications:

Full Range Class D

Signal to noise ratio: 93dB

LPF: 40-250Hz

HPF: 40-250Hz

Bass Boost: 0 to 12 dB

Operation voltage: DC 9-16V

High-level input

 

Mounting Dimensions:

8.08" Long * 5.12" Wide * 1.93" Tall

(205mm Long * 140mm Wide * 49mm Tall)

 


Installation Tips:

1. Use pure OFC Copper Wiring. Make sure to use the correct gauge wiring, for the CT-80.4D we suggest using wiring that 4GA, anything smaller is never recommended for this amplifier. We do not recommend using CCA wiring. CCA wiring is cheap, it is made using primarily aluminum. The amplifier will perform less than optimal if you decide to us CCA wiring and may even shorten the life of the amplifier. Spend the extra money and do it right, pure Copper OFC wiring that brands such as Stinger offer is the ONLY way to go.  

2. Make sure to properly ground your amplifier. We recommending grounding to the frame of your car. Make sure to clean the surface well, sand down the surface removing any paint, dirt, rust, etc.. so the connection is as strong as possible. We recommend using a bolt (do not use screws). Do not ground the amplifier to a seat bolt or any existing bolt on your vehicle (this a really a bad idea).

3. Tune your amplifier with a DD-1 or O-Scope, make sure it is not clipping. Clipping is the leading cause of subwoofer deaths.

4. Do not mount your amplifier to your subwoofer box. Mount your amplifier away from the subwoofer enclosure in a secure location. Vibration is one of the leading causes of amplifiers deaths. 

 

Note: If your amplifier is getting hot and/or shutting off it is likely because you did not follow the above. A poor ground, a loose connection, using too small of wire, or not using OFC wiring is the main reasons this would happen. 

CT-80.4 4-Channel Amplifier ® [Reservation Fee]
$10.00

You may also like